Description

Crown chlorinated rubber paints is available in all Rangi Paint stores

Type: A single pack, low build, Chlorinated Rubber based coating
Uses: A hardwearing, chemical resistant finish for use in laboratories, chemical factories,
breweries, dairies, food factories and bottling plants, hospitals, clinics etc. Widely used on
steelwork in chemical plants and marine environments
Substrates: Can be applied to suitably prepared metal, timber, plaster and concrete swimming
pools.
Advantages: Rapid drying. Non-toxic. Excellent weather, chemical, abrasion & corrosion
resistance. Superb flexibility and maintenance properties (it may be overcoated with a minimum
of preparation many years after application). Can be used at temps. below 10 degrees C. which
epoxy paints can’t.
Conditions during application; The temperature of the substrate should be minimum 10°C
and at least 3°C above the dew point of the air, measured near the substrate. Good ventilation is
required in confined areas to ensure proper drying. The moisture content in the substrate
should not exceed 3% (by weight). The coating should not be exposed to oil, chemicals or
mechanical stress until fully cured.
PRODUCT DATA:
Colour Range: Available in a few selected shades
Pack Sizes: 1 litre and 4 litres
Finish: Gloss
Thinner & equipment cleaner: Chlorinated Rubber Thinner
Dilution Ratio: Ready for use by brush. Thin up to 10% for Roller. Thin up to 40% for Spraying.
Stir well before use.
Drying Times: Surface dry 1-2 hours. Through dry 6-10 hours. Recoatable 12-16 hours in
normal, ventilated conditions.
D.F.T.: Min. 25 microns. Max. 35 microns.
Heat resistance: Approximately 100° C (212°F).
Chemical resistance: Resistant to chemical fumes and splashes, acids, alkalis. Poor resistance
to solvents and animal fats.
Crown Chlorinated Rubber Paint